Your Mortgage's Rate Floor Decides How Much a Rate Cut Can Help
Somewhere in the paperwork for most variable-rate mortgages sits one number that decides how low your rate is ever allowed to go. It's called a rate floor, and most people haven't looked at it since the day they signed.
If you're self-employed and your renewal is coming up in the next few years, that number deserves a few minutes of your attention. It sets the real limit on how much a falling rate can help you. Once you know where it sits, you can decide when to stay, when to move and when to lock in, instead of letting the calendar decide for you.
A floor shows you where rate cuts stop reaching you
A variable rate usually moves with your lender's Prime rate. A floor is a clause that says your rate won't go below a set minimum, however far Prime falls. Lenders use floors to make sure they always earn enough to cover their own borrowing costs.
Here's a simple illustration. Say Prime-based pricing would put your rate at 3.0%, but your contract floor is 3.5%. You pay 3.5%. On a $500,000 balance, that half-point gap works out to about $2,500 a year in interest ($500,000 × 0.5%) that a lower rate would have saved you.
When the floor is the rate you're actually paying, you've got a fixed rate without the certainty of a fixed term. Rates can still climb, but they can't drop any further for you.
How you feel the floor depends on your payment type
Many Canadian variable mortgages keep the monthly payment the same while the rate moves underneath it. With that setup, a binding floor won't show up in your bank account. It shows up in your statements, as less of each payment going to principal than you'd expect when rates are falling.
If your payment adjusts with the rate, you'll notice right away, because your payment simply stops getting smaller. Either way, check your annual statement and your original commitment documents. The floor should be written there in plain terms.
The stress test follows the rate you actually pay
Refinances and mid-term lender changes bring qualification back into the picture. Federally regulated lenders qualify uninsured borrowers at the higher of their contract rate plus 2 percentage points or 5.25%, under OSFI's rules as of 2026.
That means once your rate is below 3.25%, the 5.25% minimum is what counts. But if your floor holds you at 3.5%, you qualify at 5.5%. For a contractor whose income is averaged over two years of tax assessments, that extra quarter point can make the difference on a refinance or a move to a new lender.
There's some good news worth knowing. Both insured and uninsured mortgages can switch lenders at renewal without going through the stress test again, provided it is a straight switch. And some B.C. credit unions, which are provincially regulated, use their own qualifying criteria for uninsured mortgages. Floors also vary a lot from lender to lender, and some smaller mortgage-only lenders set them lower or skip them entirely.
Do the penalty math before you move
Breaking a variable mortgage early usually costs three months' interest. Going back to the $500,000 example at 3.5%, that's roughly $4,375 ($500,000 × 3.5% ÷ 4).
If moving to a lender with a lower or no floor saves you that same half point, about $2,500 a year, you'd break even in under two years. With more time left on your term, the move could pay for itself. With only a few months left, waiting for renewal is usually the better call. Legal and discharge fees shift the numbers a little, so add them in too.
The question to bring to your own file is simple: how far is today's rate from your floor, and how long until your term ends? Those two numbers tell you whether to hold, switch now or plan your renewal around something better.
If you'd like a hand finding your floor and running your own break-even numbers, send me your latest mortgage statement. I'll go through it with you and show you which of those three choices fits your situation.
Somewhere in the paperwork for most variable-rate mortgages sits one number that decides how low your rate is ever allowed to go. It's called a rate floor, and most people haven't looked at it since the day they signed.
If you're self-employed and your renewal is coming up in the next few years, that number deserves a few minutes of your attention. It sets the real limit on how much a falling rate can help you. Once you know where it sits, you can decide when to stay, when to move and when to lock in, instead of letting the calendar decide for you.
A floor shows you where rate cuts stop reaching you
A variable rate usually moves with your lender's Prime rate. A floor is a clause that says your rate won't go below a set minimum, however far Prime falls. Lenders use floors to make sure they always earn enough to cover their own borrowing costs.
Here's a simple illustration. Say Prime-based pricing would put your rate at 3.0%, but your contract floor is 3.5%. You pay 3.5%. On a $500,000 balance, that half-point gap works out to about $2,500 a year in interest ($500,000 × 0.5%) that a lower rate would have saved you.
When the floor is the rate you're actually paying, you've got a fixed rate without the certainty of a fixed term. Rates can still climb, but they can't drop any further for you.
How you feel the floor depends on your payment type
Many Canadian variable mortgages keep the monthly payment the same while the rate moves underneath it. With that setup, a binding floor won't show up in your bank account. It shows up in your statements, as less of each payment going to principal than you'd expect when rates are falling.
If your payment adjusts with the rate, you'll notice right away, because your payment simply stops getting smaller. Either way, check your annual statement and your original commitment documents. The floor should be written there in plain terms.
The stress test follows the rate you actually pay
Refinances and mid-term lender changes bring qualification back into the picture. Federally regulated lenders qualify uninsured borrowers at the higher of their contract rate plus 2 percentage points or 5.25%, under OSFI's rules as of 2026.
That means once your rate is below 3.25%, the 5.25% minimum is what counts. But if your floor holds you at 3.5%, you qualify at 5.5%. For a contractor whose income is averaged over two years of tax assessments, that extra quarter point can make the difference on a refinance or a move to a new lender.
There's some good news worth knowing. Both insured and uninsured mortgages can switch lenders at renewal without going through the stress test again, provided it is a straight switch. And some B.C. credit unions, which are provincially regulated, use their own qualifying criteria for uninsured mortgages. Floors also vary a lot from lender to lender, and some smaller mortgage-only lenders set them lower or skip them entirely.
Do the penalty math before you move
Breaking a variable mortgage early usually costs three months' interest. Going back to the $500,000 example at 3.5%, that's roughly $4,375 ($500,000 × 3.5% ÷ 4).
If moving to a lender with a lower or no floor saves you that same half point, about $2,500 a year, you'd break even in under two years. With more time left on your term, the move could pay for itself. With only a few months left, waiting for renewal is usually the better call. Legal and discharge fees shift the numbers a little, so add them in too.
The question to bring to your own file is simple: how far is today's rate from your floor, and how long until your term ends? Those two numbers tell you whether to hold, switch now or plan your renewal around something better.
If you'd like a hand finding your floor and running your own break-even numbers, send me your latest mortgage statement. I'll go through it with you and show you which of those three choices fits your situation.
Sources
Read Next
Standard Charge or Collateral Charge at Renewal? Here is Who Each One Is For
Why Your Pre-Approval Number Is the Wrong Place to Start
Pay Down Total Debt or Lower Your Monthly Payments? Here is Who Each One Is For
Before You Sign an Auto-Renewal: How to Check if Breaking Your Term Pays Off